|
LORD Engine Mounts
As a premier distributor of LORD products, Herber Aircraft offers an unsurpassed inventory of LORD engine mounts for commercial airlines, commuter aircraft, and the general aviation piston industry.
Multiplane Mounts
Standard stock Multiplane Mounts are recommended for the isolation of vibration. Lightweight and compact, they provide economical protection from lower frequency disturbances regardless of directions of the forces. They are not recommended where severe, frequently recurring shock is encountered.
These mounts are available in load ratings from 0.25 to 8 lbs. per unit. When loaded to their capacity, a system natural frequency of approximately 10 Hz results, providing effective isolation in applications where disturbing frequencies are above 20 Hz.
Low profile Avionics Mounts
Lord Corporation low profile Avionics Mounts (AM Series) set the standard for compact, high-load, high capacity isolators. They are designed to support and protect avionics equipment in all types of aircraft. Inertial guidance and navigation systems and radar components are examples of applications where these mounts are used.
In addition, AM Series Mounts are used to isolate engine/aircraft accessories such as fuel controls, pressure sensors and oil coolers.
Plate Form Mounts
Standard stock Plate Form Mounts are widely used to efficiently isolate steady-state vibration and control occasional shock.
These versatile mounts are available in load ratings of 0.25 to 12 pounds per mount. When loaded to their rated capacity, a system natural frequency of approximately 18 Hz results, providing effective isolation in applications where disturbing frequencies are 40 Hz and above.
Pedestal Mounts
Pedestal Mounts (PS Series) are designed to protect delicate electronic equipment from damaging shock and vibration. These isolators are widely used in jet aircraft, missile, spacecraft, and related ground support equipment. The low-profile design requires a minimum of headroom. Installation is simple; no special openings or tools are needed.
Bonded in BTRŪ elastomer, these mounts have high damping and wide operating temperature range.
|
